Assembly - YARDMAX YC0850 Operator's Manual

This plate compactor was partially assembled at the factory. To assemble your machine follow the below instructions.
AIR FILTER
1. Put the filter sponge element and filter core element into the
filter cover in order. (See Figure 2a)
Filter Core Element
Filter Sponge Element
Figure 2a
2. Slide the two tongue of the filter cover into the slots of the
filter seat. (See Figure 2b)
Filter Seat
Figure 2b
3. Align the bottom hole in the filter cover and the hole in the
filter seat. Fasten them together with screw. (See Figure 2c)
Figure 2c

ASSEMblY

Filter Cover
Screw
Plate Compactor
HANDLE
1. Unfold the handle. (See Figure 3a)
Upper Handle
Figure 3a
2. Mount the handle as shown. Slide the handle ends into the
engine deck slots. (See Figure 3b). Secure with the flat washers,
nuts and bolts found in packet #1 of the hardware kit.
3. Unwrap the throttle cable from around the top of the engine.
4. Unscrew bolt 5×35 from throttle control. Secure the throttle
control onto the upper handle with a flat washer 5 and the bolt
5×35 that just were unscrewed. (See Figure 3c, illustration 1 & 2)
5. Fasten the throttle control cable with cable fasteners.
15
mm
16
mm
15
mm
Lower Handle
16
mm
Figure 3b
1
Operator's Manual
»
M10 × 70
(×2)
2 M5
(×1)
Assembly
|
8