Adjusting The Lcd Panel Angle; Resetting The Microprocessor; Remote Control; Starting Up The Unit - Pioneer AVH-Z7000DAB Operation Manual

Adjusting the LCD panel angle

Important
• If you can hear the LCD panel knocking against your vehicle's console or dashboard, touch
the flap menu to temporarily level the LCD panel.
• When adjusting the LCD panel angle, be sure to adjust from the flap menu. Forcibly adjusting the LCD
panel by hand may damage it.
1
Press and hold OPEN/CLOSE to display the flap menu.
2
Touch (tilt down) or
viewable angle.
NOTE
As the set angle is saved, the LCD panel will automatically be adjusted to the same position the next
time the LCD panel is opened.

Resetting the microprocessor

CAUTION
• Pressing the RESET button resets settings and recorded contents to the factory settings.
– Do not perform this operation when a device is connected to this product.
– Some of the settings and recorded contents will not be reset.
8
En
(tilt up) to adjust the LCD panel to an easily
• The microprocessor must be reset under the following conditions:
– Prior to using this product for the first time after installation.
– If this product fails to operate properly.
– If there appears to be problems with the operation of the system.
1
from
Turn the ignition switch OFF.
2
Press RESET with a pen tip or other pointed tools.
Settings and recorded contents are reset to the factory settings.

Remote control

The remote control CD-R33 is sold separately. For details concerning operations, see the
remote control manual.

Starting up the unit

Connect the Digital Radio tuner to the unit before starting it up (refer to the Installation
Manual) otherwise an error message appears on the display.
1
Start the engine to boot up the system.
The [Select Program Language] screen appears.
NOTE
From the second time on, the screen shown will differ depending on the previous conditions.
2
Touch the language.
3
Touch .
The [Location Setting] screen appears.
4
Touch the item to select the using location.
5
Touch .
The [Speaker Mode Settings] screen appears.
6
Touch the speaker modes.
[Standard Mode]
4-speaker system with front and rear speakers, or a 6-speaker system with front and
rear speakers and subwoofers.
[Network Mode]
3-way system with a high range speaker, middle range speaker and subwoofer (low
range speaker) for reproduction of high, middle and low frequencies (bands).