Advertisement
Figure 5
REAR HANGER
9.
From the vehicle rear, route the
tailpipe over the rear end. Start
the tailpipe hanger pin into the
corresponding vehicle rubber hanger.
Install the tailpipe into the Banks
Muffler outlet. Lightly tighten the rear
muffler hanger clamp to secure the
tailpipe (see Figure 5).
10.
Adjust the Tailpipe Tip 1" under
the rear fender such that the tip
position is aesthetically pleasing (see
Figure 5).
CAUTION: IF THE TAILPIPE IS
IN CONTACT WITH THE REAR
UNDERCARRIAGE FENDER LINING,
USE TEMPLATE 1 TO TRIM THE
LINING AS SHOWN IN FIGURE 6.
11.
With the exhaust positioned
properly, begin to tighten the clamps
starting with the ones closest to the
front of the vehicle and working your
way back. Torque the exhaust clamps
BANKS TAILPIPE
FORWARD
evenly to 35 ft-lbs. Make sure that
each slip is fully inserted (+/-
All rubber hanger should be facing
forward (see Figure 7).
12.
Remove the protective covering
from the tailpipe tip.
CAUTION: THE PROTECTIVE
COVERING MAY IGNITE AND
BURN IF NOT REMOVED PRIOR TO
RUNNING THE ENGINE.
13.
Your system includes two
(2) Banks Power logos designed
to complement the Ford Factory
emblems on the vehicles front doors.
14.
Re-connect the negative battery
cable. Start the engine and listen for
exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack weld slip connections
to prevent disengagement is
recommended. The Banks Monster
Exhaust installation is now complete.
3/4" - 1"
BANKS
MONSTER TIP
96524 v.3.0
1
⁄
")
4
7
Advertisement
