Table of Contents
Advertisement
Power indicator
Undock button
Power button
Universal Seral Bus
2.0 port
DC IN 19V jack
LAN jack
HDMI out port
Using TOSHIBA Network Attached Storage Utility
This utility is only for TOSHIBA Tablet NAS dock.
■
You must dock the device to a NAS Dock before you use TOSHIBA
Network Attached Storage Utility.
■
Refer to
details.
You are able to access TOSHIBA Tablet NAS Dock easily by using Network
Attached Storage Utility.
To launch Network Attached Storage Utility, tap Start → All Programs →
TOSHIBA → Utilities → TOSHIBA Network Attached Storage Utility.
User's Manual
The Power indicator normally glows white when
the dock is turned on. However, this indicator will
glow orange while starting the dock.
Press this button to Undocking your device. For
details, please refer to
adaptor
Press this button to turn the dock on and off.
Four Universal Serial Bus ports, which comply to
the USB 2.0 standard, are provided.
The AC adaptor connects to this jack in order to
power the device and charge its internal
batteries. Please note that you should only use
the model of AC adaptor supplied with the device
at the time of purchase - using the wrong AC
adaptor can cause damage to the device.
This jack lets you connect to a LAN. The adaptor
has built-in support for Ethernet LAN (10
megabits per second, 10BASE-T), Fast Ethernet
LAN (100 megabits per second, 100BASE-TX).
Some models are equipped with a Gigabit
Ethernet LAN (1000 megabits per second,
1000BASE-T).
HDMI out port can connect with Type A
connector HDMI cable.
HDMI cable can send video and audio signals. In
addition to this, it can send and receive control
signals.
Using the TOSHIBA Tablet Dock
Hardware & Options Operation
Connecting the AC
section.
section in this chapter for
68
Advertisement
Table of Contents
