Download Print this page

Texsport 14228 Operating Manual page 3

Carlisle insta-light dual burner propane stove/grill

Advertisement

Step 2..........Make sure that the burner control valve knobs is turned off. Twist in a
clockwise direction
Step 3..........Make sure regulator assembly rubber seal is clean and undamaged
and in its proper centered position.
Step 4..........Attach the propane cylinder onto the regulator assembly (hand tighten
only). Insert tube into the inlet housing on the right side of the stove. In-
sert the tube fully into the inlet and turn the collar clockwise to tighten.
(When installed correctly the propane cylinder and regulator and tube
assembly will slant slightly toward you. The propane cylinder does not
rest flat on the surface).
Step 5..........Please check all connections for leaks using soapy water. Bubbles will
form if there is a leak present.
Step 6..........When you are sure there are no leaks, you may proceed to setup/
lighting your stove.
DO YOU SMELL GAS? IF YES, THERE IS A LEAK.
IS THE CONNECTION AREA EXTREMELY COLD?
WHEN YOU ARE SURE THERE ARE NO LEAKS,
YOU MAY PROCEED TO SETUP/LIGHTING YOUR STOVE.
Step 1..........Open case cover assembly and position two side windshields by insert-
ing notched supports into the cover.
Step 2..........Turn the burner control valve knob counter clockwise to a low or
medium setting. Gas will begin to flow and now press the ignition but-
ton repeatedly until burner lights.
Step 3..........If stove fails to light, turn off the valve. Allow any gas to dissipate and
check for a fuel blockage while following all the safety instructions
listed.
Step 4..........Repeat above instructions for lighting grill.
Step 1..........After burner has ignited, adjust to desired heat level.
Step 2..........While ignited DO NOT touch the cooking area. Only the control knob
should be touched during operation.
Step 3..........Stove surface is very hot and should not be handled or moved, except
after being shut down.
Step 4..........Allow stove to cool for 15 minutes before moving or storage.
IF SO, THERE IS A LEAK
DO NOT USE STOVE IF IT IS LEAKING.
SETUP/LIGHTING YOUR STOVE
USING YOUR STOVE
3

Advertisement

loading