Texsport 14444 Operating Manual

Thank you f or buyi ng a T exs por t ut hent i c dvent ur e G ear pr oduct . W e
hope you enj oy your new heat er and t hat i t w i l l s er ve you f or m any year s
t o com e. W e encour age you t o r ead and under s t and each s t ep of t he
s et - up and s af et y oper at i on i ns t r uct i ons pr i or t o w or ki ng w i t h t hi s w ok.
FOR OUTDOOR USE ONLY
GENERAL SAFETY INFORMATION
• DO NOT expose the propane bulk tank to excessive heat.
• lways inspect the wok, bulk tank and connections for
damage, debris or dirt before attaching the wok to the bulk
tank.
• DO NOT use or operate if the wok burner or bulk tank is
damaged.
• When storing or transporting wok, always disconnect the bulk
tank and store it in a cool, well ventilated location in an
upright position.
• Be sure connection to bulk tank is tightly secure (hand tighten
only) prior to each use.
• Never operate the wok near any flammable liquid or vapors.
Keep all flammable or combustible materials away from bulk
tank and flame.
• Discontinue operation of the wok and close valve if:
– ambient temperature drops below -10˚ F.
– there is no fuel remaining in the bulk tank
– combustion becomes unstable
– lighting cannot be performed quickly and easily
– you experience repeated flame outs
• Should blockage occur in the fuel jet do not attempt to clear
with a metal object. Call Texsport Customer Service at
800-231-1402 8 M – 5PM CST Mon-Fri.
• Never leave heater unattended when hot or in use.
• KEEP OUT OF RE CH OF CHILDREN!
2
INSTRUCTIONS FOR USE
WOK FR ME SSEMBLY – SSEMBLE OUTDOORS
Step 1 ....Unpack wok. Dispose of all packing material. Carefully compare
contents to Illustration 1.
Step 2 ....Screw 3 support feet
onto the small frame ring
as shown.
Step 3 ....Screw the 3 legs onto the
small frame ring as shown.
Step 4 ....Place burner support ring
over legs and screw onto
the legs as shown.
3
Step 5 ....Screw large ring to the
top of the legs on support
ring as shown.
Step 6 ....From under the burner
support ring, insert screw
from burner into the hole
on the ring. and secure
from underneath.
Step 7 ....This is how your burner
should look like once
attached.
Step 8 ....Screw regulator hose into
the burner. Hand tighten
only.
Step 9 ....This is how your Wok
Stand should look.
4