LG SJ7 Owner's Manual page 14

14 Connecting
4. The Primary unit and Secondary unit will be
automatically connected.
- When this unit is successfully connected,
SOUND BAR or REAR appears in the display
window of Primary unit.
- White LED on the front of Secondary unit
turns on.
,
Note
If the connection is failed or disconnected, the
2
LED indicator turns on red.
Manually pairing Secondary unit
When the pairing operate abnormally, you can check
red LED on the Secondary unit and the Secondary
unit does not make sound. To solve the problem,
follow the steps below.
1. Turn off the Primary unit.
2. Press PAIRING button on the rear of the
Secondary unit.
- The white LED on the front of the Secondary
unit blinks.
3. Turn on the Primary unit.
4. Pairing is completed.
- The white LED on the front of the Secondary
unit turns on.
,
Note
y It takes a few seconds (and may take longer)
for the Primary unit and the Secondary unit.
to communicate with each other and make
sounds.
y The closer the Primary unit and the
Secondary unit., the better sound quality. It is
recommended to install the Primary unit and
the Secondary unit as close as possible and
avoid the cases below.
- There is an obstacle between the Primary
unit and the Secondary unit.
- There is an device using same frequency
with this wireless connection such as
a medical equipment, a microwave or a
wireless LAN device.
- Keep the Primary unit and Secondary unit
away from the device (ex. wireless router,
microwave oven, etc.) over 1m (3 feet). to
prevent wireless interference.
>1m
(3 feet)