Reversing The Door Swing - Kenwood KIFF7017 Installation Instructions Manual

installation

reversing the door swing

tools required: Philips style screwdriver / Flat bladed screwdriver / Hexagonal spanner
• Ensure the unit is unplugged and empty.
• To take the door off it is necessary to tilt the unit backwards. You should rest the unit
on something solid, e.g. a chair just below the top panel.
• All parts removed must be saved to do the reinstallation of the door.
• Do not lay the unit flat as this may damage the coolant system.
• We recommend that 2 people handle the unit during assembly.
• If you want to have the door swing reversed, we recommend that you contact a
qualified technician. You should only try to reverse the door yourself if you believe that
you are qualified to do so.
1. The side at which the door opens can be
changed from the right side (as supplied)
to the left side, if the installation site
requires. Tilt the appliance slightly towards
the rear and prop it securely. Unscrew the
door hinge screws and remove the hinge
pin bracket. Open the door a little way and
lift it out upwards.
2. Unscrew the middle hinges and remove,
then remove freezer door. Unscrew the
lower hinge.
3. Screw the lower hinge to the opposite side,
then replace the freezer door and hold in
position.
4. After placing the freezer door, screw the
middle hinge back onto the opposite side
of the unit.
• Ensure the freezer door is aligned
horizontally and vertically, so that the
seals are closed on all sides before
finally tightening the hinge.
7