Kenwood KIFF7017 Installation Instructions Manual page 17

Built-In Fridge Freezer
KIFF7017
installation instructions
PARTS LIST
G
x 2
Use anti-cut safety gloves whilst
performing the installation.
• You may need:
x 8
K
x 1
(at the back of fridge)
01
( m m )
(UK) (EU)
2 0 0
2
cm
5 6 8
5 6 0 -
L
200 cm 2
Ensure there is clearance each side of the unit to allow
slight sideways movement for servicing when required.
04
Slowly and carefully push the unit into the
installation compartment.
07
Cut the rubber strip to length and place at the sides
of the cabinet cover. If the strip is curved, it can
beome straight again by heating with a hair dryer.
10
54mm
(L+5)mm
x 1
Ensure the correct measurement is used for the
installation of Part A. Tighten the screws and place
Cover C onto Part A.
02 03
40mm
K
min.
200cm 2
Remove part K from the rear and reattach to the front.
Tighten the top hinge bracket.
05 06
G
4
mm
Tighten the bottom hinge and place the cover on Tighten the top hinge brackets and place the screw
top. cover.
08 09
Loosen the screws slightly to adjust the bracket Tighten the screws and place the cover.
placement until it's in contact with the cabinet, then
tighten the screws to the cabinet.
11 12
Adjust the position of Part B, make sure Part A can Tighten the screws and place the Cover D onto Part B.
smoothly slide into Part B.
K
KIFF7017-Installation-170801V1