Safety; Symbols Used; Safety Rules - Senco SHS51XP Installation Instructions Manual

SAFETY

4 Safety

4.1 Symbols used

Danger
Ignoring this warning can result in injury.
Warning
Ignoring this warning can result in injury or severe damage to the device.
Caution
Ignoring this warning can result in minor damage to the device.
Info
Important information.

4.2 Safety rules

• The user has read and is fully familiar with the manual!
• Only fasteners from Senco are used. These are tested by Senco for these devices.
• The Smart Bridge receives the correct maintenance (see Maintenance chapter).
• The user and the employees who work on the Smart Bridge or in the vicinity wear safety glasses and the correct
hearing protection.
• Before a button is operated, the user must check that he can safely press this button.
• The operating pressure does not exceed 8 bar.
• The devices never tack 2 x in the same location (the tacks can ricochet off the tacks that are already present).
• The devices and sensors are firmly secured and correctly adjusted (see adjustments)!
• No people on the worktable.
• No objects may be placed on the Smart Bridge or table which the Smart Bridge has to pass over or that can
obstruct the passage of the Smart Bridge.
• You must ensure that the sheet material lies flat so that it does not obstruct the passage of the tacking machines.
• If deviating cases are encountered, you must immediately inform Senco.
• Ensure that children do not have access to the installation.
• During maintenance, disconnect the compressed air.
• Only persons who have read and are fully familiar with operating instructions may operate the installation.
• Safety precautions may not be removed or rendered inoperative.
• Do not place anything on or underneath the installation.
• Ensure that there is sufficient ambient lighting.
• During the work, always ensure that 1 or more persons are present.
• The installation may not be put into use before all settings and adjustments have been properly made.
• Do not reach into the installation with your hands or with objects.
• In the event of malfunctions, service personnel must be deployed.
• Work may not take place without hearing protection.
• Nothing on the installation may be modified.
• Warning signs on the installation must remain clearly legible and, if necessary, renewed.
• The system in which the Smart Load is installed must have its own safety feature to prevent unexpected stapling.
• The system in which the Smart Load is installed must have safety features and/or safety instructions to make
working with the system safe! Verpa-Senco cannot be held liable for this!
GB
5 5