Water Inlet; Water Outlet - Bosch WLT series Instruction Manual And Installation Instructions

Water inlet

Notes
Do not bend, squash, modify or cut
■
through the water supply hose
(otherwise its strength is no longer
guaranteed).
Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may become
damaged.
Optimum water pressure in the mains:
100-1000 kPa (1-10 bar)
When the tap is open, the water flow
■
is at least 8 l/min.
If the water pressure is higher than
■
this, a pressure-reducing valve must
be installed.
Connection
Connect the water supply hose to the
water tap (¾" = 26.4 mm) and to the
appliance (not necessary for Aqua-Stop
models):
Aquastop
■
Standard
■
Carefully turn on the tap and check that
the connection points are not leaking.
The screw connection is under
Note:
water pipe pressure.
Positioning and connecting

Water outlet

Caution!
Water damage
If the drain hose slips out of the wash
basin or the connection point during
draining due to high water pressure, any
escaping water may cause water
damage.
Secure the drain hose so that it cannot
slip out.
Do not kink the water drain hose
Note:
or put strain on it lengthways.
You can lay the water drain hose as
follows:
Outlet in a sink
■
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of
scalding if you come into contact
with hot detergent solution e.g. if hot
detergent solution is being drained
into a wash basin.
Do not reach into the hot detergent
solution.
Caution!
Damage to the appliance/fabrics
If the end of the drain hose is
immersed in the drained water, water
may be sucked back into the
appliance and may damage the
appliance/fabrics.
en
15