Table of Contents
Advertisement
proDuct Set up
Where to position your airStream10
It is important that you consider carefully in advance where your AirStream 10 will be
situated and make sure that it is:
•
on a flat and stable surface.
•
Within 1.8 metres of a power socket.
•
Where you have good wireless network reception.
•
If you are not using the wireless connection, you must be near, or have access
to a ethernet point.
•
Where you can fully extend the telescopic aerial when listening to DAB or FM
stations.
•
Away from bright sunlight or heat sources, such as a radiator
•
not in a humid or very damp place such as a bathroom
Switching on and connecting to your network.
Also see the Initial Set Up Guide.
1.
Connect the mains power lead into the socket on the bottom right hand side of
the AirStream10 (see the image on page 3) and plug the power adaptor into the
mains power wall socket and switch on. If you are using an ethernet network
lead (supplied) you can connect it at this stage also.
2.
'DeSIGn FoR SounD, STARTInG ...' will be displayed followed by an un-set
time and date.
1
DeSIGn FoR
SounD
2
STARTInG
3
1
00:00
00/00/0000
4
2
3.
Press the 'Stand By' button (see the image on page 3). The main menu will be
displayed (if it is not displayed, press the menu button):
4.
Turn the 'Tune/ Select Dial' to highlight and select 'System Settings'
display the 'System Settings' menu:
5.
Press the 'Tune/Select Dial' to select 'network' which will then bring up the
'network settings' menu. Press the 'Tune/Select Dial' again to select and start
the 'network Wizard'. The wizard will automatically scan for available Wi-Fi and
Wired networks and will display a list for you to choose which network to connect
to.
6.
Turn the 'Tune/Select Dial' to your chosen network and press to select. If you are
using the wired connection method, select '[WIReD]' from the list (please go to
step 8. If the network does not have any security, 'Please wait connecting', and
then 'Connected' will be displayed.
3
network settings
1
Please wait.
Connecting...
4
2
7.
If your network does have security, the wizard will prompt you to enter the relevant
Wired equivalent Privacy (WeP) or Wi-Fi Protected Access (WPA) code or pass
phrase. This is done by turning the 'Tune/ Select Dial' to highlight the appropriate
character, then pressing it to select. When your key has been entered, turn the
dial to highlight 'ok' and press to select.
monitoraudio.co.uk
Main Menu
1
3
Internet AirStream 10
Music player
DAB
FM
2
4
Aux in
System settings
1
3
network
>
Time/ Date
>
Language
>
LCD Standby-Backlight
>
2
4
Factory reset
network settings
3
1
R
4
2
. This will
3
Connected
4
5
Hide quick links:
Advertisement
Table of Contents
