Operation Mode 3 (Manager Mode) - Panasonic WX-CC2010 Series Operating Instructions Manual

Operation Mode 3 (Manager Mode)

In this operation mode, you can assign the role of manager / assistant personnel to each user.
• The manager has the communication priority to assistant personnel. The manager can cut into a conversation with a cus-
tomer even when one of assistant personnel is communicating with the customer in the TALK mode.
• In the PAGE mode, the manager can communicate with one of the assistant personnel.
WX-CC2010
WX-CC2010
TRANSCEIVE
MONITOR R ULTRAPLEX II
1 DNR DNR
2 POWER
3 VEHICLE
PRESENT
4 A
B
Center Module Dip Switch Setting
[D·THROUGH]:
[MANAGER]:
Note: Set WX-CT2030 Transceiver in the area that covers the moving range of the manager.
18
3.05 m
{10 ft.}
or more
WX-CT2030
*
w
WX-CT2020 / WX-CH2050 Dip Switch Setting [Manager]
[D·THROUGH]:
SDT
[MANAGER]:
ON
[Role Assignment]:
[Area Expansion]:
WX-CT2020 / WX-CH2050 Dip Switch Setting [Assistant]
[D·THROUGH]:
[MANAGER]:
[Role Assignment]:
[Area Expansion]:
:Communication area for Manager
WX-CT2020 / WX-CH2050 can receive
the transmission signals from WX-CT2030.
:Communication area for Manager / Assistant Personnal
• WX-CT2020 / WX-CH2050 for the manager
can receive the transmission signals from WX-CT2030.
• WX-CT2020 / WX-CH2050 for the assistant personnel
can receive the transmission signals from WX-CC2010.
• The manager has the communication priority.
:Non-communication Area
* w shows the transceiver No.
It is the same as TRANSCEIVER jack No.
of WX-CC2010.
SDT
ON
Manager
Normal
SDT
ON
Assistant
Normal