Remote Transfer Data - ABB SPAU 341 C User Manual

Remote transfer
data
In addition to the event data all input data (I-
data), setting values (S-data), control parameters
(V-data), and some other data of the module
Data
Inputs
Aut
Tap-changer operating (TCO)
Outputs
Raise
Lower
Raise
Lower
Enable parameters 011...012
Settings used
Present checksum of switchgroup SGF1
Present value of tap-changer position
corresponding to low mA signal
Present value of tap-changer position
corresponding to high mA signal
Present value of output pulse duration
Main settings
Main checksum of switchgroup SGF1
Main value of tap-changer position
corresponding to low mA signal
Main value of tap-changer position
corresponding to high mA signal
Main value of output pulse duration
Second settings
Second checksum of switchgroup SGF1
Second value of tap-changer position
corresponding to low mA signal
Second value of tap-changer position
corresponding to high mA signal
Second value of output pulse duration
can be read over the SPA bus. Also, part of the
data can be altered by commands given over the
SPA bus.
Para- Data Values
meter direct.
I1 R 0 = manual
1 = auto
I2 R 0 = TCO not activated
1 = TCO activated
O1 R 0 = signal not active
1 = signal active
O2 R 0 = signal not active
1 = signal active
O11 R,W(P) 0 = signal not active
1 = signal active
O12 R,W(P) 0 = signal not active
1 = signal active
O21 R,W(P) 0 = output relays disabled
1 = output relays enabled
S1 R 0...255
S2 R 0...34
S3 R 1...35
S4 R 0.5...10.0 s
S21 R,W(P) 0...255
S22 R,W(P) 0...34
S23 R,W(P) 1...35
S24 R,W(P) 0.5...10.0 s
S41 R,W(P) 0...255
S42 R,W(P) 0...34
S43 R,W(P) 1...35
S44 R,W(P) 0.5...10.0 s
9