Related Manuals for Lukhan LK-P20W
Summary of Contents for Lukhan LK-P20W
- Page 3 Cover open button MSR Slot (Optional) Power switch Paper feed button DC Power IC Card Slot (Optional) Belt clip hole Battery SERIAL...
- Page 4 Printer Battery Belt Buckle 1. Align the battery hook as shown in the picture. Recharger Serial Cable USB Shelded Cable 2. Push the battery into the printer until it locks in place. Roll paper Quick Manual Printer case Battery recharger Strap...
- Page 5 Insert screw into belt clip. 1. The battery can be charged only when the temperature is 0~40 2. Be sure that the printer is turn off and the battery to be charged is installed. 3. Connect the charger to the printer. 4.
- Page 6 Place the paper roll as shown. Rotate the belt clip as shown Make sure the paper is placed in Press the cover open button and open right direction. Pull a short length of paper out of Remove the battery as shown the printer and close the cover.
- Page 7 1. Turn the printer off. 2. Press and hold the feed button. 3. Press and release the power button and keep the feed button pressed. 4. When printing starts, release the feed button. 1. The Printer can be connected to devices equipped with wi• (802.11b/g) communication capacity (PDAs, PCs, etc.) 2.
- Page 8 : Exposure to Radio Frequency Radiation. This device complies with part 15 of the FCC Results. Operation is subject to the following two conditions: (1) This Device may not cause harmful interface, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the LK-P20W and is the answer not in the manual?
Questions and answers