Table of Contents
Advertisement
ASSEMBLY INSTRUCTION
ATTENTION:
Please follow these assembly instructions step by step to assemble this trainer bike.
1. Install the Front and Rear Stabilizers
Fix the front stabilizer (2) and rear stabilizer (3) to
the main frame (1) with the carriage bolts (13), arc
washers (14) and Acorn nuts (15).
2. Install the Handlebar Post
Connect the sensor wire (17) from the main frame (1)
to the connective wire (18) from the handlebar post
(4). Put the end of tension controller (20) into the
spring hook of tension cable (16). Pull the resistance
cable of tension controller (20) up and force it into
the gap of metal bracket of tension cable (16) as the
picture shows. Finally, insert the handlebar post (4)
to the main frame (1) and secure with the Allen bolts
(19) and arc washers (14).
Ensured the Cable has been connected correctly as
shown.
3. Install the Handlebar
Fix the handlebar (5) onto the handlebar post (4) with
spring washers (25) and bolts (26). Cover the
handlebar chuck cover (27) onto the handlebar (4).
4
Advertisement
Table of Contents
