Fast-Switch Attachment System - Bolens Husky 900 Manual

Slide universal joint over end of
splined power-take-off shaft, align-
ing holes in joint and shaft and secure
with cap screw and lock nut. Just slide
attachment drive and PTO drive shaft
universal joint together, slip pins into
hitch points and connect attachment
lift lever with pin and hitch point. The
PTO (power-take-off) drive shaft
is located under the front of the tractor
frame and is connected to the engine
by a drive belt. This assembly has a
drive shaft which is splined at both
ends so that front, center and rear
power attachments can be coupled
directly to it. Universal joints on the
attachments are equipped with
needle-bearings allowing you to raise
or lower attachments (with lift lever)
while the tractor is under full power.

Fast-Switch Attachment System

Your HUSKY tractor has the fastest
attachment switch system
dustry. No belts to adjust ... no tools
needed.
in the in-
CAUTION: Always remove universal
joint from power-take-off shaft when at-
tachments are removed from tractor. If
the joint is not removed and the power-
take-off is engaged, damage will result
from whipping action of the free joint.
17