Advertisement
■ Precaution for Use
・Vacuum Disc Mate IQ1300A is exclusively for Analog 12 inch record disc (30 cm).
・Do not use Vacuum Disc Mate IQ 1300A for other than the record disc adsorption.
・Do not vacuum up trash and dust in the suction box. If dust gets collected in the pump, it may cause the breakdown.
・Do not leave a record disc on the Magnesium Discs for long hours, as a tip of the sealing rubber falls down
causing the suction failure.
・When not using, cover the record player with dust cover so that magnesium discs does not get dusty.
・When absorption is not properly operated or when other trouble occurs, see When You are Having trouble
on page 5.
・In a extremely cold place, it lowers pressure of dry battery, which may prevent the limiter of the suction
box from operating. If it does not adsorb well because sealing rubber gets stiff, raise the room
temperature before operation.
■ Operation Preparation
Alkaline Battery
① Take a lid from the back of the suction box and put DC9V (006P dry battery) in it.
＊Because life of dry battery is short, alkaline battery is recommended.
＊Suction duration is appox. 30 secs. and automatically stops. Additional operation can be manually
done by pressing the switch on and off for start and stop. Operate it for its needs.
② Attach the accompanying hose to the suction box (insert the hose in and
tighten the screw). Insert the L-shaped Jack of the tip into the suction collar.
＊When insertion is completed, press the operation switch. Make sure the
operation lamp lights up and the suction collar vacuums up.
③ Remove the turntable mat of the record player and set the magnesium
disc on it.
＊ It may not be used depending on the size of the center spindle. Moreover,
in case the turntable is not flat and has lumpy surface, Magnesium disc may
not be stable and cannot be set on it. Please call your purchased store for
further assistance.
＊ In case surface of the record and the tonearm are not horizontal with each other due to the thickness of
Magnesium disc, please adjust the height of the tonearm.
④ Clean the back of a record disc
Clean the back of a record disc (the surface that is in touch with sealing rubber) with purified
water or a commercially available record cleaner. Likewise, clean the sealing rubber when necessary.
If dust adheres to a record disc and sealing rubber, the suction power may be reduced and a record
disc may be damaged.
Tighten
Push the seat board, and L-shaped jack can be
removed.
Insert L-shaped jack
〈Supported Record Player〉
Total length
Straight section
Less than 22mm
More than 10 mm
Spindle
Turntable
Please check the length after
removed turntable sheet of the
record player.
Advertisement
