Service Mode Table 1 - Panasonic SA-HT330GCT Service Manual

SA-HT330GCT / SA-HT330GCP

14.2. Service Mode Table 1

The service modes can be activated by pressing various button combination on the player and remote control unit.
Player buttons Remote control unit buttons
STOP
14.3. DVD Self Diagnostic Function-Error Code
Error Code
U, H error
U11 Focus error
H01 Tray loading error
H02 Spindle servo error
H03 Traverse servo error
H04 Tracking servo error
H05 Seek error
H06 Power error
H07 Spindle motor drive error
DSC related
F500 DSC error
F501 DSC not Ready error
F502 DSC Time out error
F503 DSC communication Failure
F504 Error adjusting DSC data slice offset
F505 DSC Attention error
F506 Invalid media
ODC related
F600 Access failure
information caused by demodulation
error
F601 Indeterminate sector ID requested
F602 Access failure to LEAD-IN caused by
demodulation error
F603 Access failure to KEYDET caused by
demodulation error
F610 ODC abnormality
F611 6626 QCODE don't read Error
F612 No CRC OK for a specific time
F620 Laser safeguard: high temperature
condition
F621 Laser safeguard:
condition
F630 No reply to KEY DET enquiry
F631 CPPM KEY DET is not available till
the FILE terminal
F632 CPPM KEY DET is not available
Disc code
F103 Illegal highlight Position
HIC Error
F4FF Force initialize failure (time out)
Micro computer error
F700 MBX overflow
F701 Message command does not end
F702 Message command changes
F880 Task number is not appropriate
0 Error code display
5 Tilt adjustment
6 Area number and broadcasting system check
7 Built-in program version check
DISPLAY DVD laser drive current check
3 CD laser drive current check
PAUSE Writing of laser drive current value after replacement of optical
pickup (Do use this function only when optical pickup is
replaced.)
Initialization of the player (factory setting is restored.)
Used after replacement of micro-computer and its peripherals
and printed circuit board.
Error Content
(Spindle servo, DSC (IC8271) SP motor, CLV servo error)
(Traverse motor, IC8251)
Cannot switch off the power because of the panel and system computer communication error
Spindle motor
DSC (IC8271) stops in the occurrence of servo error (startup, focus error, etc.)
DSC-system computer communication error (Communication failure caused by idling of DSC)
Similar disposal as F500
Communication error (result error occurred although communication command was sent)
Similar disposal as F500
Disc is flipped over, TOC unreadable, incompatible disc media
to management Operation stopped because navigation data is not accessible caused by the demodulation
defect
Operation stopped caused by the request to access abnormal ID data
LEAD IN data unreadable
Access failure to CSS data of disc
No permission for command execution
Access failure to seek address in CD series
Access failure to ID data in DVD series
circuit failure
(for internal use only)
(CPPM file system is unreadable caused by scratches)
Been revoked or falsified
Big possibility of disc specification violation during highlight display
When replying message to disc manager
Next message is sent before replying to disc manager
Message is changed before it is sent as a reply to disc manager
Message coming from a non-existing task
Application
Additional error explanation
36
Note
(Refer to the item, "14.3.
").
Refer to the item "17.4.
Optical adjustment").
Refer to the item "14.1. ".