Cleaning The Beard Styler Attachment - Philips SW175 Manual

1
1
2

Cleaning the beard styler attachment

2 Rinse the shaving unit under a warm tap for
some time.
3 After rinsing the shaver under the tap, hold it
upright for 10-15 seconds to allow water to run
out of the bottom.
4 Press the release buttons on the shaving unit
and pull the shaving head holder off the
shaving unit.
5 Rinse the shaving head holder and hair
chamber under a warm tap for 30 seconds.
6 Carefully shake off excess water and let the
shaving head holder air dry completely.
7 Reattach the shaving head holder to the
shaving unit ('click').
Clean the beard styler after each use.
1 Pull the comb off the beard styler.
Note: Grab the comb in the center to pull it off
the beard styler. Do not pull at the sides of the
comb.
2 Switch on the shaver.
15
English