Related Manuals for IKUSI IK 3
Summary of Contents for IKUSI IK 3
- Page 1 IK 3 USER’s MANUAL Paseo Miramón 170 - 20014 Donostia - San Sebastián, Guipúzcoa /Spain - tlc@ikusi.com...
-
Page 2: Safety Instructions
Avoid knocking or dropping the set. • Do not use the set if failure is detected. REMEMBER Changes or modifi cati ons not expressly approved by IKUSI could void the user’s authority to operate this equipment. Cr 1 Tx Cr 1... -
Page 3: Technical Description
02- TECHNICAL DESCRIPTION 181,16 Label for crane identi fi cati on Opti on: Range Limiter External and extractable EP70 Manoeuvre elements EEPROM module Contact key Batt ery Start Pushbutt on 10.- 3,5” TFT Display STOP butt on 11.- Lateral pushbutt ons 02- TECHNICAL DESCRIPTION... - Page 4 03- START UP In order to turn the transmitt er ON (OPERATION mode), please follow the next steps: 1- Place a charged batt ery in the transmitt er. The char- 2. Turn the contact key to the positi on I. It is not neces- 2- Turn the contact key.
-
Page 5: Troubleshooting
04- MAINTENANCE RECOMMENDATIONS This equipment is designed for use in an industrial environment. However, we recommend you follow the instructi ons below to extend the life span of your remote control set: • Use the belt provided with the transmitt er to prevent the transmitt er from falling. •... -
Page 6: Charger And Battery
06- CHARGER AND BATTERY TECHNICAL SPECS CB70 BT24IK AC Power Supply 230 Vca +/- 10%, 50 Voltage 4,8 V Opti onal 115 Vca, 60 Hz Capacity 2400 mAh NiMH Charging temperature From 0º to 45ºC DC Power Supply from 10,5 V to 35 V Discharge temperature From -20º... - Page 7 MECHANICAL SPECS: 06- CHARGER AND BATTERY...
Need help?
Do you have a question about the IK 3 and is the answer not in the manual?
Questions and answers