PV plant. It is essential to ensure that the correct grid code/safety setting has been selected for the relevant region. Each Zeversolar inverter is set to a default grid code which is based on the serial number suffix that can be found on the label affixed to the inverter and its packaging, see Figure 1 below.
1.4 When is Power Management & EEG Required Please note: For countries that do not require Power Management then it is recommended that both the Power Management and EEG settings are deactivated from the front LCD panel. 1.4.1 Power Management Power management is required when the PV plant requires one or more of the following modes of operation: ...
1.5 Hardware Requirements Eversol TL – please note that this series of inverter has been discontinued; Zeverlution S; Evershine TL. 1.6 Software Requirements Refer to the table below for the firmware (FW) versions that are required for each product.
Page 7
Navigate to the “Normal” screen by pressing the control button on the front panel. 2. When the “Normal” screen is displayed, press and hold the control button for approximately 10 seconds. 3. To deactivate the Power Management & EEG setting, press the control button repeatedly until “ActiveP&EEG : OFF”...