Installation; Front Panel Control; Configuring Outputs For Hdmi Or - Octava HDHC48MX-V1.3 Installation Manual

Installation:

1) Verify that the Configuration Switch is in the factory default mode.
2) Connect the DC power adapter
3) Configure output A and B to either 1) HDMI OR 2) RJ-45 CAT 5/6 output.
The default from factory is RJ-45 CAT5/6 mode.
To configure each output, please follow these instructions.
Output Mode
RJ-45 CAT 5/6 Press the front panel button for the desired
mode output for ~ 10 seconds. The LED will
indicate a "c" for Cat 5/6 mode.
Press the front panel button for the desired
HDMI Mode output for ~ 10 seconds. The LED will
indicate a "0" for HDMI mode.
quick configure Press and HOLD the front panel A and B
button for 10 seconds.
To quickly change -The LED will indicate a "c" for Cat 5/6
ALL outputs to mode.
CAT 5/6 or HDMI -The LED will indicate a "0" for HDMI mode.
4) Connect the Monitors.
HDMI-If you are connecting HDTV with HDMI, simply connect the HDMI cable
CAT5/6 -If you are connecting using the RJ-45 CAT 5/6 output, you must use
a HDMI-CAT 5/6 Receiver. (see page 5 "Connecting Using CAT 5/6 outputs")
5) Connect the HDMI sources to the HDMI INPUTS
6) Turn On your HDTV and at least 1 HD source
Action Indicator
5
Configuring Outputs for HDMI or RJ-45 :
Output ASCII Command
A <STX>911<ETX>
A <STX>912<ETX>
B <STX>921<ETX>
B <STX>922<ETX>
Disabling /Enabling Front Panel IR Remote Receiver:
To disable the front panel IR remote receiver-insert the plastic plug into the
IR jack as shown.
Front panel
IR receiver -disabled
Mode
HDMI mode
RJ-45 CAT 5/6 mode
HDMI mode
RJ-45 CAT 5/6 mode
Front panel
IR receiver -enabled
14