Installation; Washing Procedure - Pyle PUCWM11 Instruction Manual

1. Place the unit on a leveled floor and in a well-ventilated place.
2. Do not install on a weak or rough flooring.
3. Make sure to connect the green earth wire located at the back of the unit to any
grounded object. Do not connect the grounding wire on a water pipe or gas pipe.
4. Lay down the drain hose.
5. Use the water inlet hose provided to connect to a faucet/tap (water supply) into
the washtub water supply inlet.
6. Adjust the level of water according to the clothes type and quantity.
7. Set the wash timer to desired setting will tum on the washing machine.
Washing :
1. Set the wash selector to Gentle or Normal. Please see Table 1 for wash mode.
2. Insert water hose to Inlet or prepare a pall of water (If no water Is available from
faucet) to fill washtub halfway.
3. Put the detergent depending on the water volume and detergent package
indication.
4. Set the Wash Timer knob to 1 minute to dissolve the detergent.
5. Put clothes one by one in the washtub and push it towards the bottom. Continue
adding water up to desired level.
6. Set the Wash Timer to appropriate setting. Refer to Table 1.
Rinsing :
• Rinse clothes by following the washing procedure. But this time, do not put a
detergent.
Washing Suggestions :
1. When washing heavily soiled cotton or linen clothes, wash them first in a clean
water for 2-3 minutes then drain the dirty water. Proceed with the usual washing
procedure. This process will improve the washing effect and reduce detergent
consumption.
2. Add small amount of detergent on cuffs, collars and other seriously soiled
places and rub them by hand or with a laundry brush.

INSTALLATION

WASHING PROCEDURE