Page 1
OWNERS INSTRUCTION MANUAL 54”/137cm Neptune with LED INSTALLATION OPERATION MAINTENANCE CAUTION READ INSTRUCTIONS CAREFULLY FOR SAFE INSTALLATION AND FAN OPERATION. IF UNSURE CONSULT A QUALIFIED ELECTRICIAN SUITABLE FOR 230V/50 CYCLE ELECTRICAL SUPPLY Enquiries on installing your fan please call our help line on 01959-564440 technical@fantasiaceilingfans.com...
IMPORTANT NOTES : Please minimise risk of electrical shock by switching off electricity supply at the main circuit breaker. And read the following point carefully. To ensure the success of the installation be sure to read the instructions and study the diagrams thoroughly before commencing.
Installing the fan All electrical work should only be undertaken after disconnection of the power by removing fuses or turning off the circuit breaker to ensure all pole isolation of the electrical supply. Your fan can be installed in either of two options. It can be installed as a flush mount fan (Picture B), i.e.
The following steps will guide you to a successful installation: Hanging bracket installation Attaching the blades Down rod assembly style or flush mount assembly Remote Control and Wiring instructions Installing shade 1. Hanger bracket installation The hanging bracket should be screwed on to a firm flat surface.
Page 7
After finishing blade assembly, replacing the PIC. B upper housing back and screw it down tightly. (See PIC. B) Please be noted, the position of arrow pointed in the picture must be align reverse switch CLIPPING LATCH when the housing is screwed back. The canopy can be screwed onto the fan at same time if you would like to install your fan in flush mount style.
Page 8
Once the drop rod assembly has been fitted- Lift the fan up to the hanger bracket, steer the ball in from the side of the bracket and lower it into the recess of the bracket. Rotate the ball around until the groove in the side of the ball aligns with the protrusion on the upper edge of the recess.
Page 9
Remote Control and Wiring Instructions Your fan is supplied with a radio frequency remote control unit, and the fan does not have a pull switch for speed control, the fan can only be controlled by remote control. You can find the unit in the box.
Page 10
Put the receiver of remote control through hanger bracket (as picture). Connect the A.C. power supply wires that come from the ceiling to the Brown and blue wire of receiver which is mark with label “L” & “N”. In most cases, BROWN/RED wire is LIVE is connected to “L”...
5. install bulb and shade This supplied with light 3000K dimmable, the LED light was pre-assembled under the fan and secured with a transparent flat cover for safety concern (DO NOT REMOVE). Now is a good time to test that the fan and remote control operates correctly.
Blade balancing Whilst every precaution is taken at the factory to ensure your fan is of the highest quality, imbalance may occur. This may be due to slight irregularities in the blades or blade carriers. Deviating from these instructions can cause further problems. The following procedure may help to rectify the situation.
Ceiling Fan Warranty. You must have the original purchase receipt or bill of sale to make a warranty claim. No claim will be accepted unless proof of date of purchase is available at the time of making the warranty claim. Ceiling Fan Warranty Period.
Page 14
54”/137cm Neptune with LED FANTASIA DISTRIBUTION LTD. Unit B. The Flyers Way, Westerham, Kent, TN16 1DE Tel : (01959) 564 440 Fax : (01959) 564 829 E-MAIL: info@fantasiaceilingfans.com...
Page 16
54”/137cm Neptune with LED Please cut out this warranty page and send it in an envelope to the address below. Alternatively please go to our website www.fantasiaceilingfans.com and fill in the warranty section there. FANTASIA DISTRIBUTION LTD. Unit B. The Flyers Way, Westerham, Kent, TN16 1DE...
Need help?
Do you have a question about the Neptune and is the answer not in the manual?
Questions and answers