PAC RadioPRO 4 Manual

Introduction & Features
The RP4-MZ11 interface allows the replacement of a factory radio in select Mazda vehicles with MS-CAN radios. Using
this interface will retain factory features such as steering wheel controls (SWC), programming of the clock on the OEM
of this interface also allows you to program two radio functions to each SWC button by using short press long press dual
command functionality. The RP4-MZ11 also provides data bus driven outputs such as retained accessory power (RAP),
vehicle speed sensor (VSS), illumination, reverse trigger and parking brake.

Important Notes

1.
vehicle (see next page for setting chart).
2.
3.
5.
6.
speaker wire and use the aftermarket radio's low level outputs.
7.
8.
9.
10.
2007-2009 CX-9, 2007-2009 CX-7

Wiring Connection Chart

Interface Connector

Vehicle Speed
Red
(1 amp)
2nd SWC Input
(See Installation
steps on next
page for proper
connection)
Green
P ifi A C ti
Radio Replacement & Steering Wheel Control Interface
Vehicle Connector
Yellow
Ground
output (See
Installation Steps on
next page for proper
connection)
Illumination
White
Front L - input
Front R - input
Green
Rear L - input
Purple
Rear R - input
® | Clearwater, FL 33760 | Ph. 866-931-8021 | support@pac-audio.com
www.pac-audio.com
RP4-MZ11
for MazdaVehicles
SWC Connector
Kenwwod, Newer
JVC,
3.5mm Jack
Clarion, Pioneer,
Dual, Lightning
Rev. 012615
Page 1