Desa LDL3924NR Owner's Operation And Installation Manual page 20

OPERATING HEATER
FAHRENHEIT/CELSIUS TEMPERATURE
INDICATION
To toggle between temperature degrees Fahren-
heit and Celsius perform the following steps.
1. Press the up and down key until the small
triangle is to the left of the clock icon (see
Figure 29).
2. From time 0:00, press the left key 10 times.
The display will then show the transmitter
address (frequency).
3. Press the right key to toggle from °F to °C
and vice versa.
4. Press the left key to exit this function.
SETTING FLAME HEIGHT
Press the up or down key until the small triangle
is to the left of large flame icon at the top of
LCD display (see Figure 29). Press the left or
right key to set the desired flame height. Six
flame levels are available from 1 (minimum)
to 6 (maximum).
SETTING ROOM TEMPERATURE
Press the up or down key until the small triangle
is to the left of the thermometer icon (see Figure
29). Press the left or right key to set the desired
room temperature.
SETTING TIMER (Sleep Function)
Press the up or down key until the small triangle
is to the left of the clock icon (see Figure 29).
Press the left or right key to set the desired
sleep time. Maximum sleep time is 90 minutes,
in 15 minute increments. When desired time is
set, press the up or down key to start the timer.
When the desired time has elapsed, the appli-
ance will automatically switch off.
CHILD SAFETY LOCK-OUT
To lock the remote control keys, press the
On/Off key then immediately press the up key
(see Figure 29). The lock-out function is active
when the lock icon is lit. Repeat key sequence
to unlock keys.
0
Available from Allparts Equipment and Accessories - 1-877-475-5660 - www.allpartsinc.com
Continued
LOW BATTERY DETECTION AND
BACKUP
A battery icon will be displayed on the LCD
display when batteries are low in the remote
control (see Figure 29).
When the receiver detects a low battery condition;
• Three acoustic "beeps" are generated from
the receiver
• Appliance is turned off and will go to the
maximum flame height
• Execution of commands is inhibited until
batteries are replaced
When batteries are low, it is not possible to
turn on the appliance with the remote control.
Appliance can be turned on or off manually
by setting the backup switch of the receiver to
MAN position (see Figure 13, page 13). Remote
control and receiver will restart normal opera-
tion after batteries are replaced. See Installing
Batteries for Remote Receiver and Hand Held
Remote Control, page 13.
TIMEOUT
If appliance is turned on and no command is
sent to the receiver for 24 hours, appliance will
automatically shut down. Commands sent after
shutdown will be executed normally.
Small Triangle
Icon (Function
Indicator)
Flame
Height
Indicator
Ther-
mometer
Icon
Clock
Icon
Left and
Right Keys
Increase
and
Decrease
Set Points
On/Off
Button
Figure 29 - Remote Control
LCD Display
Room
Temp.
Display
(°F or °C)
Sleep
Timer
Display
Lock-Out
Indicator
Low
Battery
Indicator
Up and
Down
Keys
Select
Available
Functions