Description On Network Control Operation; Network Control Operation - Proxima M1010X User Manual

Description on network control operation

Network control operation

Function: This function is designed to remote control computer in the same LAN.
Preparation
1 Required equipment: Projector, connection, network cable
2 Connection:
Connect your projector to a router or switch in the LAN with normal or jumper network
cable. In case a normal network cable failed to connect successfully, use a jumper cable
instead.
3
powered on.
Operation steps
1 Power on your projector.
2 Acquire the IP address, with DHCP set to on and auto IP allocation set to On. (You
may set DHCP to Off and set up IP address manually if you are somehow familiar with
networking.)
3 Enter the network setup menu
(1) Press MENU key on remote
controller or top of the control panel,
press
icon.
(2) Press ENTER key or
network menu displays.
(3) Press
settings and press ENTER to
(4) Press
(5) Press
ENTER to wait until the "Please
wait.." message disappears.
key to select network
key and the
key select network
key to set DHCP On and
key to select OK, press
设置
network
network setup
network setup state
设置
network
network setup
network setuo state
LAN
network setup
DHCP
close
IP Address
192 . 168 . 1 . 100
255 . 255 . 255 . 0
Subnet
192 . 168 . 1
Gateway
DNS 192 . 168 . 1
YES
. 1
. 1
NO
67