TECHVIEW QV-3162 User Manual page 31

USER MANUAL
Area: To setup motion area, click Setup.
By default, the whole screen is marked for motion detection (red blocks). If you want to disable the
motion detection on an area, you need to click the grid cursor and then drag the mouse to highlight
the scope to unmark the area (transparent block). After setting is completed, right click the mouse
button to return and click Save to make the area setup effective.
Area is unmarked
Motion Detection Area Setup
Post Recording: You can set how long after an event occurs that the WIRELESS NVR will
continue to record. The recommended recording length is 30 seconds but it can be set higher up
to 5 minutes.
Show Message: Check the box to display "M" icon on the screen when the motion is detected.
Send Email: You can let the WIRELESS NVR to send you an auto-email when the motion is
detected.
Full Screen: If this function is enabled and a motion is detected in a channel, you will see that
channel in full screen.
Record Channels: Here you can select which channels you want to include to the motion
detection. If the motion is detected, the recording will start immediately on those channels.
31