Transport Wheel Height Adjustment - Champion 100379 Operator's Manual

100379 - FRONT TINE TILLER
Depth Regulator Lever Adjustment
This regulator lever controls the tilling depth of the tines.
Remove pin and clip and slide regulator lever up or down as
required. Reassemble pin and clip.
The "travel position" (highest hole) raises the tines
approximately 1-1/2 in. (4 cm) off the ground, allowing the
tiller to be moved without the tines contacting the ground. This
setting should also be used when starting the engine.
Moving the regulator lever upward will increase the tilling depth.
The lowest notch allows a tilling depth of approximately 6 in.
(15 cm), depending on soil conditions. For best results, always
begin tilling at a very shallow depth setting and gradually
increase the tilling depth.
Do not attempt to till too deeply too quickly.
Gradually work down to deeper tilling depths.
Place the Depth Regulator Lever in the "travel" position
before starting the engine. This position prevents the tines
from touching the ground until you are ready to begin tilling.
Failure to follow this warning could result in personal injury
or property damage.

Transport Wheel Height Adjustment

The quick store transport wheels allow the operator to easily
move the tiller to and from the garden and stow in moments
when its time to start tilling.
1. Pull spring loaded locking pin away from the tiller body.
WARNING
2. Swing the wheel assembly upward for tilling depth
adjustment or downward for transport mode. Insert the
spring loaded locking pin to lock wheel height at desired
level.
ASSEMBLY
16