Switching On/Off The Unit; Open/Close The Monitor And Angle Adjustment - Pyle PLTV65R Owner's Manual

OPERATION

SWITCHING ON/OFF THE UNIT

Switch on the unit by pressing
POWER button (1) on the front panel
or POWER button (34) on the remote
control. When system is on, press it
again to turn the unit off.
OPEN/CLOSE THE MONITOR AND
ANGLE ADJUSTMENT
Press OPEN/CLOSE button (2) on the
front panel or point the remote control
to IR (10) on the front panel and press
OPEN button (35), the monitor will
stretch automatically.
OPEN/CLOSE button
Fig.1
When the monitor stretches to a certain
location, it will turn upward
automatically and stop at vertical
position.
Fig.2
Adjusting the viewing angle.
When the monitor doesn't move, you
can press ANGLE+ button (49) or
ANGLE button (50) on the remote
control to turn the monitor upward or
downward at fine steps to get a
desired viewing angle. And you can
rotate the monitor left and right from
the central viewing position at a
certain angle range manually.
Don't rotate the monitor forcibly to
avoid mechanical damage.
/
Return the monitor to the central
viewing position, then press
OPEN/CLOSE button (2) on the
front panel or press OPEN button
(35) on the remote control, the
monitor will turn downward
automatically.
When the monitor turns downward to a
certain angle, it will draw in.
NOTE:
When the monitor is on the central
viewing position, switch the ignition
key to "ACC OFF", the monitor will
turn downward and draw in
automatically.
When the monitor is on the central
viewing position, disconnect the
battery cable and then reconnect the
battery cable, the monitor will turn
downward and draw in automatically.
10
Fig.3
Fig.4
Fig.5