Table of Contents
Advertisement
6 FLASH MEMORY
The decoder board supports AMD class Flash memories. Currently 4 configurations are
supported:
FLASH_512K_8b
FLASH_1024K_8b
FLASH_512Kx2_8b
FLASH_512Kx2_16b
The Vibratto permits both 8- and 16-bit common memory I/O accesses with a removable storage
card via the host interface.
7 SERIAL EEPROM MEMORY
An I2C serial EEPROM is used to store user configuration (i.e. language preferences, speaker setup, etc.) and
software configuration.. Industry standard EEPROM range in size from 1kbit to 256kbit and share the same IC
footprint and pinout. The default device is 2kbit, 256kx 8, SOIC8 SGS Thomson ST24C02M1 or equivalent.
8 AUDIO INTERFACE AUDIO SAMPLING RATE AND PLL COMPONENT
CONFIGURATION
The MT1379 audio mode configuration is selectable, allowing it to interface directly with low-cost audio DACs
and ADCs. The audio port provides a standard I
S interface input and output and S/PDIF (IEC958) audio
2
output. Stereo mode is in I
S format while six channels Dolby Digital ( 5.1 channel) audio output can be
2
channeled through the S/PDIF. The S/PDIF interface consists of a bi-phase mark encoder, which has low skew.
The transmit I
S interface supports the 128, 192, 256, 384, and 512 sampling frequency formats, where
2
sampling frequency Fs is usually 32 kHz, 44.1 kHz, 48 kHz, 96 kHz, or 192 kHz. The audio samples for the
I
S transmit interface can be 16, 18, 20, 24, and 32-bit samples.
2
For Linear PCM audio stream format, the MT1379 supports 48 kHz and 96 kHz. Dolby Digital audio only
supports 48 kHz. MT1379 incorporates a built-in programmable analog PLL in the device architecture in order
to generate a master audio clock. The MCLK pin is for the audio DAC clock and can either be an output from or
an input to the MT1379. Audio data out (TSD) and audio frame sync (TWS) are clocked out of the MT1379
based on the audio transmit bit clock (TBCK). Audio receive bit clock (RBCK) is used to clock in audio data in
(RSD) and audio receive frame sync (RWS).
9
FRONT PANEL
9.1 VFD
CONTROLLER
The VFD controller is a NEC uPD16311. This controller is not a processor, but doesinclude a simple state
machine which scans the VFD and reads the front panel button matrix. The 16311 also includes RAM so it can
store the current state of all the VFD icons and segments. Therefore, the 16311 need only be accessed when the
VFD status changes and when the button status is read. The MT1379 can control this chip by using 3 wire
communication.
10 CONNECTORS
10.1 SCART CONNECTORS
Pinout of the scart connector:
1 - Audio Right Out
2 - Audio Right In
3 - Audio Left / Mono Out
4 - Audio Gnd
5 - Blue Gnd
Advertisement
Table of Contents
