Powermeter And Sensor Alignment - SRM PowerMeter 7 Short Manual

INSTALLATION OF THE SrM TrAINING SYSTEM
POWErMETEr ANd SENSOr ALIGNMENT
1. Install your new PowerMeter and cranks according to the
original manufacturer instructions. If a bottom bracket
came with your new PowerMeter you must install that.
2. Adjust the cadence magnet so it is 3-5mm from the
lid on the back of the PowerMeter.
3. Tighten the cable guide bolt to fix the cadence magnet.
4. The PowerMeter is ready to pair.
- Page 8 -