Craftsman 320.39587 Operator's Manual page 13

7.
8.
Smooth out the sandpaper by pressing it tightly against the bottom of the
platen (front to back).
Insert the back end of
the sandpaper into the
back paper clamp, fit the
sandpaper as tightly as
possible, and lift up on the
back clamp lever to lock it
into place. This will securely
clamp the paper to the back
of the platen. The sandpaper
should now be positioned
tightly against the underside
of the platen from front to
back and securely clamped in
place (Fig. 4).
Paper
goes (
under the
clamp
to clamp pa_
PAPER PUNCH
A paper punch is provided with
the sander so you can punch
properly aligned holes into the
sandpaper. This is done after the
paper is installed onto the sander.
To punch holes, line up the front
and side of the sander over the
paper punch as shown in Fig. 5,
then lower the sander onto the
punch template while applying
pressure. Make sure that the holes
are punched all the way through
the paper and clear the holes in
the sandeds platen.
NOTICE: Punching holes
propedy is a necessary step for
the dust-collecting system to
operate properly.
Fig. 5
!
@_per punch
DUST BAG
,_ WARNING: Do not use the dust bag when sanding metal. Using the dust
bag when sanding metal creates a fire hazard, which could damage the tool and
lead to serious personal injury.
Your sheet sander is supplied with a dust bag to help you keep the working area
clean. The dust bag is idea[ for smaller jobs.
13