When Using Remote Control - Pyle view PLDVD170 Operating Instructions Manual

When using remote control

Preparing the remote control
Insert the batteries into the remote control so you can use it to operate the DVD video player.
Make sure to match the +and - on the lithium button cell(3V, CR2025) to the marks inside the
cell compartment.
1) Open the cover,
pull the cover as illustrated
Operating with the remote control
1)This section shows you how to use the
remote control. Point the remote control
at the remote sensor and press the buttons.
Not used when using the remote sensor
on the remote control eye jack.
The remote range: about 4m from the front
of the remote sensor.
(Is) off axis: more than 30 in each direction
of the front of the remote sensor.
2) Remote sensor and remote control eye jack
Connect the remote control eye jack to the
remote sensor unit.
Do not expose the remote sensor of the DVD player to a strong light source such as direct
sunlight or other illumination. If you do so, you may not be able to operate the DVD player via
the remote control.
Notes on battery
To operate the remote control correctly, follow the instructions below.
Do not insert cell into the remote control in the wrong direction.
Do not charge, heat, open, or short-circuit the cell. Do not throw cell into a fire.
If the remote control does not function correctly or if the operating range becomes reduced,
replace all cell with new one.
Notes on the remote control
Direct the remote control at the remote sensor of the DVD player.
Do not drop or give the remote control a shock.
Do not leave the remote control near an extremely hot or humid place.
Do not spill water or put anything wet on the remote control.
Do not disassemble the remote control.
L
7
2)Insert cell (3V),Close the cover
DVD player
Remote sensor
Remote eye jack
With about 4m
Double-side tape