sauter TRA 410 Operating Instructions Manual page 15

TRA 410, 421
Description of operation
P100015830 C
TRA 410 TRA 421 Display symbol
P
P P
P
P
P P
Procedure
Set the weekly switching programme
Factory setting for weekly switching programme
(daily Mon-Sun):
• Switching command P1: 06h00 to 08h00 com-
fort mode
• Switching command P2: 15h00 to 22h00 com-
fort mode
• P3 and P4 are not preset and can be selected
freely.
The switching commands (switch-on and switch-
off points) must be programmed in ascending
sequence.
If you add a switching command before P1, then
P1 becomes P2 and the new command becomes
P1.
Note: The thin bar at the bottom shows the time
scale in hours; the six boxes stand for 6 hours
.
The thick bar at the top shows the comfort mode in
hours .
For settings, see section 3.3 Einstellen des Wochen-
schaltprogramms
Correction effect of the wall temperature (only
internal sensor)
Factory setting: 0 °C
Press to confirm the selection.
Turn to set the correction that you want (steps of
0.1 °C).
The effect of the wall temperature can be corrected
by ±2 °C.
Press to confirm the entry.
Set the display backlight
Factory setting: 50
Press to confirm the selection.
Turn to change or switch off the backlight:
0
25
50
75
100
Press to confirm the entry.
Reset to factory settings
Press to confirm the selection.
Turn to set to YES.
Press the rotary knob for 5 seconds.
A restart is performed: all of the settings made are
reset to the factory settings; the time and the week-
days must be set again.
Back
Press to confirm the selection.
You quit the menu.
Note: Returns to the basic level if no setting is made
for 30 seconds.
= off
= level 1
= level 2
= level 3
= level 4
15/19