Transport And Storage; Service And Repair; Disposal; Troubleshooting - RIDGID SeeSnake microReel Operator's Manual

Inspection system
Hide thumbs Also See for SeeSnake microReel:
Table of Contents

Advertisement

SeeSnake

Transport And Storage

Do not expose to heavy shocks or impacts during trans-
port. If storing for an extended period, remove batteries.
Store in environments within temperature range of -4°F to
158°F (-20°C to. 70°C).

Service And Repair

Improper service or repair can make the microReel
unsafe to operate.
Service and repair of the microReel System must be per-
formed by a RIDGID Independent Authorized Service
Center.
For information on your nearest RIDGID Independent
Service Center or any service or repair questions:
Chart 1 Troubleshooting
PROBLEM
Camera video image not
seen.
SOS blinking on LCD.
(Some SeeSnake CCUs.)
16
Find Quality Products Online at:
®
microReel Inspection System
WARNING
PROBABLE FAULT LOCATION
No power to SeeSnake CCU or microEXPLORER
Camera monitor connector.
Connections faulty.
Monitor set to wrong source.
Batteries low.
No video signal.
GlobalTestSupply
www.

Disposal

Parts of the microReel System contain valuable mate-
rials and can be recycled. There are companies that spe-
cialize in recycling that may be found locally. Dispose of
the components in compliance with all applicable regu-
lations. Contact your local waste management authority
for more information.
equipment that is no longer usable must be collected
separately and disposed of in an environmentally correct
manner.
Check power is correctly plugged in.
Check switch on monitor/display unit.
Check alignment and pins of connection to
microReel System unit from camera control or
display unit.
Check orientation, seating, and pin condition in the
SeeSnake connection.
Set video source as described in display unit
manual.
Recharge or replace batteries.
Check source setting of monitor and re-seat cable
connection.
Ridge Tool Company
Do not dispose of electrical equipment
with household waste!
According to the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its implemen-
tation into national legislation, electrical
SOLUTION
.com
744-034-529-EN-0A Rev A
sales@GlobalTestSupply.com
10/22/2015

Advertisement

Table of Contents
loading

Table of Contents