Adjustments - Magnum MI-81350 Operating Manual

Adjustments

Warning: Always disconnect the machine from
the power source before making any
adjustments.
Failure to heed this warning can lead to serious
personal injury.
To adjust outfeed table
The outfeed table should be set level with the
highest point of the knives, Fig. 14. The height
of the outfeed table should be verified and
adjusted prior to first use. It should also be
verified and readjusted periodically to
compensate for knife wear and also upon knife
replacement.
The Jointer table is adjusted at manufactory and
should no further adjustment required. To align
the tip of knife & outfeed table as below if
necessary.
1. Make sure that the machine is
disconnected from the power source.
2. To give yourself unimpeded access to the
cutterhead and upper pulley, remove the
blade guard.
3. Set a straightedge (A, Fig. 14 & 15) onto
the outfeed table so that it sits over the
cutterhead but does not completely cross
the gap between the tables and do not
touch the infeed table.
4. Turn the upper pulley by hand, until any
one of the knives is at its highest point.
5. Loosen the CAP screw (B, Fig. 16) by
8mm Hex. wrench.
6. Push up or down the height adjustment
handle (C, Fig. 16) to adjust the outfeed
table height so that the knife tip barely
touches the straight-edge
7. Re-tighten the CAP screw (B) to secure the
outfeed table in position.
8. If the outfeed table couldn't low to correct
position release the Hex. nut (D) then loosen
the Hex. bolt (E), Fig. 17.
9. Lower the outfeed table to the location of the
appropriate by height adjustment handle (C)
then tighten the CAP screw (B).
10. Re-tighten the Hex. nut (D)
11. Re-tighten the Hex. bolt (E).
.
8
OUTFEED
TABLE
FIG. 14
A
FIG. 15
C
FIG. 16
FIG. 17
A
INFEED
TABLE
(RIGHT)
B
B
D
E