Anti Tip Tubes; Comfort Seat - Unicare Health ANSA Relax Instruction & Safety Manual

Anti-tip tubes
The anti-tip tubes (1) provide additional safety for inexperienced users
when they are still learning how to operate their wheelchairs. Anti-tip
tubes (1) prevent a wheelchair from tipping over backwards. By pulling
the interlock (2), the anti-tip tube can be height adjusted. There should
be a gap of 2,5 cm to the fl oor. To go up or down a step (e.g. kerb) the
anti-tip tubes must be swung upwards, to prevent them from touching
the ground.

Comfort Seat

The Comfort seat allows you to be seated for a long period of time,
because of the anatomical, shaped seat plate and anatomically shaped
cushions. The cushion is held by Velcro and can also be removed. The
cover can be washed (see the instructions on the cushion).
Seat depth
After loosening the screws (1), you can set the seat depth to the desired
position. Then tighten the screws again (see the page on torque).
CAUTION!
The maximum seat depth (see marking and endstop) must not be
exceeded.
Seat width adjustment
You can extend the width of the seat of your wheelchair by removing
the upholstery (1).
Adjustable seat angle (2°-20°)
By pulling the lever the seat is released and can be put into the desired position. When you let go, the
seat is automatically fi xed in the new position.
CAUTION:
The angle-adjustable seat may only be used with anti-tip tubes. The gap between the anti-tip tubes and
the ground must be a maximum of 2.5 cm.
CAUTION:
To ensure the correct function of the cables, these must never be taut.
CAUTION:
There is a danger of trapping your fi ngers when you adjusting the seat.
CAUTION:
Never adjust the seat angle if the wheelchair is on a slope.
16
T 08 9351 7500 E info@unicarehealth.com.au W www.unicarehealth.com.au