Angle Adjustable Footplate; Headrest; Seat Height Adjustment - Unicare Health ANSA Relax Instruction & Safety Manual

Angle Adjustable Footplate

The footplate can be fl ipped up to make it easier to transfer to/from the
chair. It can be adjusted to alter the angle to the ground. Loosen screw
(1) and set the desired angle. Then tighten the screw. By loosening the
screw (1) the footplate can be adjusted both forwards and backwards.
Make sure that after any adjustment work, all screws are tightened
correctly (see the page on torque). Ensure that you maintain the
minimum gap to the fl oor (2.5 cm).
CAUTION!
While making the adjustment, there must be no load on the footboard!
Calf pads can be width and depth adjusted. To do this, release the
screws (1) and push the calf pad into the relevant position. After making
the adjustment, all screws must be correctly tightened. By pushing the
calf pad on the footrest tube, you can set the height.

Headrest

The headrest can be raised, moved sideward and moved horizontally
both forwards and backwards. Height adjustment: Pull the release
knob (1) and set the desired height. Make sure that the release knob
is always correctly engaged. Horizontal adjustment: Open the release
lever (2), set the desired position and pull the release lever fi rmly again.
Side adjustment: After loosening the screws (3) the headrest can be
pushed sideways. Tighten screws again (see the page on torque).

Seat height adjustment

Seat height can be adjusted by changing the position of the castors
and rear wheels (see table 1) as well as by using the seating unit. To
make the adjustment the 4 screws (4) must be loosened and the seating
unit must be screwed into the new position (A, B). After making the
adjustment, all screws must be correctly tightened (see the page on torque).
12
T 08 9351 7500 E info@unicarehealth.com.au W www.unicarehealth.com.au