Backrest Height - Unicare Health ANSA Relax Instruction & Safety Manual

Backrest Height

Comfort backrest
The Comfort backrest will allow you to sit for long periods of time, with
side support. To remove it, pull it upwards and forwards. The cushion is
held by Velcro and can also be removed. The cover can be washed (see
the instructions on the cushion).
Adjustable backrest height
The backrest height can be adjusted to various positions by releasing the 4 clamp screws (1). Then
tighten the clamp screws again (see the page on torque).
Side pads
The angle, depth and height of the side pads can be adjusted and they
can also be swung-away or removed.
• Depth adjustment: Loosen the screw (1) and put the pad into its new
position. Tighten the screw.
• Angle adjustment: Push the pad upwards, put the pad at the desired
angle and then let go of it again. It will automatically click into place.
This is how you swing the pad away.
• Height adjustment: Loosen the screw (2) and put the bracket into
the desired position. If there is not suffi cient adjustment, the pad can
also be fi tted into a new position on the bracket. Then tighten the
screws.
Adjustable back angle (8°-40°/50°)
By pulling the lever (1) the backrest is released and can be put into the
desired position. When you let go, the backrest is automatically fi xed in
the new position.
CAUTION:
The angle-adjustable backrest may only be used with anti-tip tubes. The
gap between the anti-tip tubes and the ground must be a maximum of
2,5 cm.
CAUTION:
To ensure the correct function of the cables, these must never be taut.
CAUTION:
There is a risk of injury when you adjusting the backrest.
CAUTION:
Never adjust the backrest if the wheelchair is on a slope.
T 08 9351 7500 E info@unicarehealth.com.au W www.unicarehealth.com.au
14