Related Manuals for RIDGID POWER SPIN+
Summary of Contents for RIDGID POWER SPIN+
- Page 1 Drain Cleaner Operator’s Manual POWER SPIN + ™ 99 Washington Street Melrose, MA 02176 Phone 781-665-1400 Toll Free 1-800-517-8431 Visit us at www.TestEquipmentDepot.com...
-
Page 2: Table Of Contents
POWER SPIN + ™ Drain Cleaner Table of Contents Safety Symbols.....................ii Specific Safety Information Drain Cleaner Safety ..................1 RIDGID Contact Information ................1 Description ......................1 Specifications.......................2 Pre-Operation Inspection ..................2 Machine and Work Area Set-Up................3 Operating Instructions..................4 Storage........................5 Maintenance Instructions..................5 Cleaning......................5 Installing Replacement Cable ................5 Troubleshooting....................6... -
Page 3: Specific Safety Information
The POWER SPIN + is not recommended for control problems leading to twisting, kinking or breaking of the cable. Twisting, kinking or use with toilets. breaking cable may cause striking or crush - ing injuries. POWER SPIN is a registered trademark of RIDGID, Inc. in the U.S. -
Page 4: Specifications
POWER SPIN + ™ Drain Cleaner causes and prevent drain cleaner dam- age. Guide AUTOFEED Tube Mechanism 1. Clean any oil, grease or dirt from all equipment, including handles and con- trols. This aids inspection and helps pre- Crank vent the machine or control from slipping from your grip. -
Page 5: Machine And Work Area Set-Up
POWER SPIN + ™ Drain Cleaner Machine and Work Area Warning Label Set-Up WARNING Drum Shaft Set up the drain cleaning machine and work area according to these proce- Figure 2 – Removing Crank Handle From POWER dures to reduce the risk of injury from SPIN + electric shock, twisted or broken ca- 8. -
Page 6: Operating Instructions
POWER SPIN + ™ Drain Cleaner • Control of the drain cleaner (and bat- er distance from the drain access in- tery powered drill if used). creases the risk of the cable twisting or kinking. If not, the drain opening will •... -
Page 7: Storage
POWER SPIN + ™ Drain Cleaner Continuing to turn the drum may cause 15. Pull any remaining cable from the line the cable to twist and kink. It may be by hand and push the cable into the necessary to back the cable out of the drum. -
Page 8: Troubleshooting
POWER SPIN + ™ Drain Cleaner 3. Remove 4 screws from drum back and re- 6. Insert about 12 inches of cable through the move drum back. guide tube into the drum. 4. Remove cable clamp screw. Remove exist- 7 . Place cable end as shown inside drum ing cable (Figure 11). -
Page 9: Lifetime Warranty
99 Washington Street, Melrose, MA 02176 TestEquipmentDepot.com ©2017, RIDGID, Inc. Printed 9/17 The Emerson logo and RIDGID logo are registered trademarks of Emerson Electric Co. or RIDGID, Inc. in the U.S. and other countries. 999-999-438.10 EC42754 All other trademarks belong to their respective holders.