Bushranger LS301 Operator's Manual page 13

2. Hold the lifting handle and slowly lower the
beam. It will lock automatically. Double
check to make sure the beam bracket is
locked onto the beam.
Do not let the beam suddenly drop.
Keep hands and fingers clear of
pinch or crush points at all times.
30
mm
Beam Lock Bracket
19
mm
Figure 7b
MANUAL TUBE
1. Remove the cap from the manual tube. 18
mm
Align the holes in the manual tube with
the holes in the tow bar. Insert and tighten
bolts and washers. (See Figure 8)
16
mm
13
mm
32
mm
Figure 8
M8 X 20
2. Reattach the cap.
LOG CRADLES
1. Align the holes on the right log cradle to the
inside and lower holes on the beam mounts.
Insert the M12x35 bolts, flat washers, and
nuts and securely tighten.
2. Follow step 1 to assemble the left log cradle.
LOG TABLE (OPTIONAL)
Refer to Figures 9 and 10 to install the work
table. Remove the bolts, flat washers, and nuts
from the inside holes. Move the log cradle
from the incline position to the horizontal
position. Align the holes on the log cradle
with the outside holes on the beam mount.
Reinstall the bolts, flat washers, and nuts.
Place the work table over the holes in the log
cradle and align the 4 holes from the work
table plate and log cradle. Insert and tighten
the M10x25 bolts, spring washers, flat washers,
and nuts.
M8x20
(x2)
Cap
Manual Tube
F
X 2
(See Figure 9)
30
mm
Inside Holes
19
19 mm
mm
18
mm
16
mm
16
mm
32
mm
13
Log Cradle (Right)
mm
13
mm
Figure 9
32
mm
M12 X 35
30
mm
19
mm
18
mm
16
mm
Inside Holes
13
mm
Outside Holes
32 Log Cradle (Right)
mm
Figure 10
M10 X 25
LOG SPLITTER
Outside Holes
M12x35
(x8)
G
X 8
M10x25
(x4)
Work Table
8
X 4
13