Assembly - Bushranger LS301 Operator's Manual

ASSEMBLY

This log splitter was partially assembled at the
factory. To assemble your machine follow the
below instructions.
WHEELS
1. Remove the anti-dust sleeves from the two
wheels. Take the anti-dust washers and
roller bearings from the wheels and set
aside for later use.
Anti-dust Washer
2.
At least two people are needed to move
the reservoir outside of the pallet. Place
the engine at the end corner of the pallet.
Use the shipping crate bottom
for balancing when installing
the wheel assembly.
3. Remove the two anti-dust sleeves from the
wheel axle.
LOG SPLITTER
10
(x2)
Anti-dust Sleeve
Roller Bearing
(x4)
Figure 1a
Reservoir with Engine
o
45
Figure 1b
Wheel Shaft
Anti-dust Sleeve
(x2)
Figure 1c
4. Assistant holds the engine, while the other
person assembles the wheel opposite of
the engine first.
32
mm
(x4)
Axle Nut
(x1)
Roller Bearing
Wheel
Cap
(x1)
Wheel Washer
(x1)
Anti-dust Washer
5. Slide the anti-dust washer and one roller
bearing onto the axle. Use a soft-faced
hammer to tap the roller bearing lightly
to make sure the bearing is in the right
position.
Slide the wheel with the valve stem facing
6.
out to the wheel axle and the other roller
bearing, then put the wheel washer against
the bearing. Use a 32mm socket to tighten
the axle nut completely.
7. Spin the wheel clockwise or counterclock
wise to ensure proper bearing seating.
8. Loosen the axle nut until it is loose enough
to turn the wheel with your fingers.
9.
Retighten the axle nut until "finger tight."
10. Insert the cotter pin through the hole in the
axle. Bend open and spread the prongs in
(x2)
Cotter Pin
(x1)
(x1)
Figure 1d
M22 X 2
4 X 50
X 2 A
X 2