Advertisement
down bolts to specification. See TORQUE SPECIFICATIONS.
Removal & Installation (1.8L)
1) Fuel pump is located in fuel tank and is integral with
fuel sending unit assembly. Relieve fuel pressure. See
FUEL SYSTEM PRESSURE RELEASE (GASOLINE). Disconnect negative battery
cable. Remove rear seat cushion. Remove 4 fuel sending unit assembly
access panel bolts and remove access panel. Disconnect harness
connector from fuel sending unit assembly.
2) Remove fuel pipe from top of fuel sending unit assembly.
Remove 8 fuel sending unit assembly hold-down bolts and remove hold-
down plate. Remove fuel sending unit assembly and "O" ring from fuel
tank.
3) Remove No. 2 fuel sending unit support and rubber cushion.
Remove fuel pressure regulator. Remove fuel pump strainer hold-down
clip and remove fuel pump strainer.
4) Remove No. 1 fuel sending unit support from fuel sending
unit plate. Remove No. 1 fuel filter cushion from fuel filter.
Disconnect harness connector from fuel pump. Remove fuel pump from
fuel filter.
5) To install, reverse removal procedure. Use NEW "O" ring on
fuel pressure regulator and fuel sending unit assembly. Tighten fuel
sending unit assembly hold-down bolts to specification. See
TORQUE SPECIFICATIONS.
Removal & Installation (3.0L)
1) Fuel pump is located in fuel tank and is integral with
fuel sending unit assembly. Relieve fuel system pressure. See
CRANKSHAFT (24X) POSITION SENSOR (DIS). Disconnect negative battery
cable.
2) Raise and support vehicle. Disconnect fuel lines and
harness connections at fuel tank. Remove fuel tank. Remove fuel
sending unit assembly cam lock ring. Lift fuel sending unit assembly
from fuel tank.
3) Disconnect fuel pump harness connector and hose clamp.
Push in release tabs on fuel pump and lift off sending unit assembly.
To install, reverse removal procedure using NEW "O" ring and gasket.
Removal & Installation (4.6L)
1) Disconnect negative battery cable. Relieve fuel system
pressure. See CRANKSHAFT (24X) POSITION SENSOR (DIS). Raise and
support vehicle. Remove the fuel sender assembly.
2) Remove fuel tank pressure sensor. Disconnect fuel pump
electrical connector. Remove fuel level sensor electrical connector
retaining clip. Remove fuel pump.
3) Push in release tabs on fuel pump and lift off sending
unit assembly. To install, reverse removal procedure using NEW "O"
ring and gasket.
FUEL PRESSURE REGULATOR (GASOLINE)
NOTE:
On 3.0L, fuel pressure regulator and fuel rail are serviced
as an assembly only. DO NOT remove pressure regulator or
pressure regulator cover from fuel rail.
See FUEL RAIL & INJECTORS.
Removal (1.3L)
Relieve fuel pressure. See
FUEL SYSTEM PRESSURE RELEASE (GASOLINE). Disconnect negative battery
cable. Disconnect pressure regulator vacuum hose. Remove fuel return
line from pressure regulator. Remove pressure regulator screws. Remove
pressure regulator from fuel rail. Remove fuel inlet "O" ring from
pressure regulator.
Advertisement
