Advertisement
2. SAFETY INSTRUCTIONS
Attention!
To protect oneself against electric shock, risk of injury and fire, basic safety measures
must be observed when using electric tools!
Before operating this electric tool, read all operating and safety instructions. Please
keep the safety instructions for future reference.
Installation
After taking the electric tool out of the packaging, first of all please check if the tool
has been damaged while in transit. Ensure that the voltage and frequency rating of the
power outlet you use matches the requirements of this tool - if not, there is danger of
Life and the possibility of damaging the tool. The flex has to be an H05VV-F 2x0.75
2
mm
. Damaged flexes must be replaced by a flex of the same type.
Check the wheel guard of the grinding disc. It has to be securely mounted, the apex
angle must not be more than 180° and it must be neither deformed nor damaged.
3. GRINDING DISC
3.1 Do only use reinforced discs with a safety limit concerning the grinding speed of
not less than 80 m/s. They must not be used beyond their expiration date. Do not use
wet discs. Unplug the tool before replacing the disc.
3.2 Only use discs that have been certified by MPA!
3.3 If you detect any damage after unpacking the tool, it has to be checked by a
qualified electrician. Disconnect it from the power supply before you open the tool.
Safe operation:
WARNING: When using electric tools, basic safety precautions, including the following,
should always be followed to reduce the risk of fire, electric shock and personal injury.
Read all these instructions before operating this product and save these instructions.
4. FOR SAFE OPERATIONS
1) Keep work area clean.
Cluttered areas and benches invite injuries.
2) Consider work area environment.
Do not expose power tools to rain. Do not use power tools in damp or wet locations.
Page 3
ANGLE GRINDER
Advertisement
