Shineray XY400-2 Maintenance Manual page 5

XY400–2 Maintenance Manual
8. In case the fuse is blown, check for the causes and, after
being repaired, replace corresponding fuse as per the
specified capacity.
9. The caps must be securely put on the terminals after the
operation is complete
10. While disassembling a connector joints with lock, release
the lock before proceeding with operation.
While disassembling a connector joints, hold the connector
body without pulling the wire harness.
Before connecting the connector, the terminals shall be free
from breaking or bending. Make sure the terminals are not too
long or are falling off.
The connector shall be fully inserted in place.
For a connector with lock, confirm whether the lock is
completely fixed.
Make sure the harness is not falling off
Confirm capacity!
Make sure the plastic jacket of the connector is securely
covering the connector without scaling off.
11. Before connecting a connector, make sure the sleeve is
not broken and the opening of the intermediate terminal is
not too large
The joint shall be fully inserted in place.
Make sure the plastic jacket is housing the terminal completely.
The opening of the plastic jacket shall not face up.
12. The harness fixing strap shall firmly button the specified
position on the frame.
13. The clamp shall reliably bite the wire harness
In case of a welded clamp, it shall not bite the wire harness
towards the weld mark
3
Overview
Crackle