Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Access security product KP-KR3
Summary of Contents for Access security product KP-KR3
- Page 1 KP-KR3 Stand-Alone Keypad & Proximity Card Reader User Manual...
- Page 2 INTRODUCTION The KP-KR3 is a two relay multifunction standalone access control keypad suitable for either indoor or outdoor use It is housed in a strong, sturdy and vandal resistant Zinc Alloy electroplated case. The electronics are fully potted making it extremely weather resistant and conforming to IP68 It supports up to 1200 users in a Card, PIN, or a Card + PIN option.
-
Page 3: Specifications
Remarks Digital Keypad-R3K User manual Screw driver Rubber bungs 6*27mm, used for fixing Self tapping screws 3.5*27mm, used for fixing Please ensure that all the above contents are correct. If any are missing please notify the supplier of the KP-KR3... -
Page 4: Installation
Installation Remove the back cover from the keypad using the supplied security screwdriver Drill four holes on the wall for the screws and one hole for the cable Fix the back cover firmly on the wall with 4 flat head screws ... -
Page 5: Quick Programming Guide
Quick Programming Guide To enter the programming mode Master code 888888 is the default factory master code To exit from the programming mode Note that to undertake the following programming the master user must be logged in To change the master code New code New code The master code must be 6 digits... -
Page 6: Connection Diagram Examples
Connection Diagram Examples Common power supply for magnetic lock (Fail open – power to lock) Common power supply for lock release (Fail secure – power to unlock) Common power supply for auto gate controller (using Normally Open contact) -
Page 7: Anti-Tamper Alarm
Remarks: the Zone 2, it can be used to operate a doorbell if there is no need to operate a second door. The wiring to connect the doorbell is via NO2 and COM2. Press #, the R3K will send out a switching signal to the doorbell, as long as you press the”... - Page 8 KP-KR3 Detailed Programming Guide User Settings To enter the programming Master code mode 888888 is the default factory master code To exit from the programming mode Note that to undertake the following programming, the master user must be logged in...
- Page 9 To add Card Users. (Method Read card Card can be added continuously without exiting programming mode This is an easy way to enter cards with auto-generated ID numbers The ID number will start from 1 if no user has been programmed To add Card Users.
- Page 10 To add Card Users. (Method Read Card Card can be added continuously without exiting programming mode Auto-generated ID numbers Card and PIN Mode To set users for Zone 1. ( To Add a card and Pin user Add the card as for a card user (The PIN is any four digits Press * to exit from the programming mode between 0000 &...
- Page 11 To delete ALL users Note: This is a dangerous Delete all users of Zone 1: 0000 option, so use with care Delete all users of Zone 2: 0000 To unlock the door (or change relay state) For a PIN user Enter the PIN then press # For a card User...
- Page 12 Keypad Lockout & Alarm Output options. If there are 10 invalid cards or 10 incorrect PIN numbers in a 10 minute period either the keypad will lockout for 10 minutes or the alarm will operate for 10 minutes, depending on the option selected below Normal status: No keypad # (Factory default setting) lockout or alarm...
-
Page 13: Reset Procedure
Reset Procedure Reset Alarm: The alarm will sound for 3 minutes. To reset, present a valid user card or enter * (Master Code) # via the keypad Reset to Factory Default: To reset to factory default, power off, then press and hold the * button and power on, release it after you hear two bleeps, the LED will turn orange.