Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Access security product KP-401-A
Summary of Contents for Access security product KP-401-A
- Page 1 KP-401-A Internal Stand-Alone Keypad (Proximity Ready) User Manual...
-
Page 2: Specifications
INTRODUCTION The K401-I is a single relay multifunction standalone access control keypad suitable for indoor use. It is housed in a strong, sturdy and vandal resistant Zinc Alloy electroplated case It supports up to 1000 users in a Card, PIN, or a Card + PIN option. The inbuilt card reader supports 125KHZ EM frequency card or key fob, and the Pin length is 4-6 digits The single relay can operate in Pulse Mode (suitable for access control) or Toggle Mode (suitable for arming/disarming alarms, switching lights, machines….etc) -
Page 3: Package Contents
Package contents K401-I Keypad Diode IN4004 (For relay circuit protection) Self Tapping Screws Wall Anchors Screw Driver INSTALLATION Remove the back cover from the unit Drill 2 holes (A,C) on the wall for the screws and one hole for the cable ... -
Page 4: Connection Diagram Examples
Connection Diagram Examples Common power supply for magnetic lock (Fail open – power to lock) Common power supply for lock release (Fail secure – power to unlock) Common power supply for auto gate controller (using Normally Open contact) Attention: Install a 1N4004 or equivalent diode across the locking device when using a common power supply to prevent any back E.M.F as the reader might damage. -
Page 5: Set Access Configuration
PROGRAMMING Programming will vary depending on access confirguration. Follow the instructions according to your access configuration Programming 1 -------------------- Configure the K401-I Change the configure settings according to your application (optional). Multiple configuration settings can be changed at one time: enter program mode, change the desired settings, then exit program mode Set Master Code The 4-6 digit Master Code is used to prevent unauthorized access to the system. -
Page 6: General Programming Information
Set Strike-out Alarm The strike-our alarm will engage after 5 failed card/PIN attempts. Factory default is OFF. The strike-our alarm can be set to deny access for 10 minutes after engaging or it can be set disengage only after entering a valid card/PIN or Master Code Programming Step Keystroke Combination... -
Page 7: Change Pin
Delete User Cards Programming Step Keystroke Combination ﹡(Master Code) # 1. Enter Program Mode 2 (Read Card) # 2. Delete Card: By card Cards can be deleted continuously 2 (User ID) # 3. Delete Card: Select Specific ID The user ID is any number from 0-999 4. -
Page 8: Reset To Factory Default
Delete Card by User ID Deleting by ID number will clear cards and PINS Programming Step Keystroke Combination ﹡(Master Code) # 1. Enter Program Mode 2. Delete User Card by User ID 2 (User ID) # 3. Exit program mode Others Reset to Factory Default: This will reset the K401-I to factory default but all card/PIN information will still be retained... -
Page 9: Function Description
K401-I- Simplified Instruction Function Description Operation Enter the Programming Mode * (Master Code) # (6666 is the default factory master code) 0（New Master Code）#（Repeat New Master Code）# Change the Master Code (code: 4-6 digits) Add Card User 1 (Read Card) # Add PIN User 1 (User ID) # (PIN) # The ID number is any number between 0 - 999.The PIN is any...