Numark Party Mix Pro User Manual page 7

20. Platter/Jog Wheel: This jog wheel controls the audio when the wheel is moved. When the
Scratch button is not active, use the jog wheel to bend the pitch of the track. When the
Scratch button is active, use the jog wheel to grab and move the audio, "scratching" the
track as you would with a vinyl record.
21. Scratch Button: Activate this button to use the Platter/Jog Wheel to grab and move the
audio, "scratching" the track as you would with a vinyl record.
22. Pitch Fader: This controls the speed of the music. Moving towards the "+" will speed the
music up, while moving towards the "–" will slow it down.
23. Sync: Press this button to automatically match the corresponding Deck's tempo with the
opposite Deck's tempo and phase.
24. Cue: When the Deck is paused, you can set a Temporary Cue Point by moving the Platter
to place the playhead at the desired location and then pressing the Cue button.
During playback, you can press the Cue button to return the track to this Temporary Cue
Point. (If you did not set a Temporary Cue Point, then it will return to the beginning of the
track.)
25. Play/Pause: Starts and suspends playback.
26. Performance Pads: These pads can be used to trigger Hot Cues, Loops, and Samples.
To change the function of the pads, press the Pad Mode button.
27. Pad Mode: Press this button to change the current function of the Performance Pads.
28. Pad Mode Indicator: These LEDs indicate the current setting of the Performance Pads.
Side Panel
1. Power On/Off Switch: Turns Party Mix
Pro on or off. Please note that while
Party Mix Pro is connected to a power
source, it does not need to be powered
on to charge the battery.
2. Power Cable Input (IEC): Insert the
included power cable here to charge
the unit. Note that the Party Mix Pro
can run off the power adapter while it
simultaneously charges the battery.
The charge indicator illuminates when
the battery is charging.
3. Aux Input: This stereo 1/8" (3.5 mm) input can be used to connect a CD player, MP3
player, or other audio source. The Aux Input volume is controlled using the Master
Volume.
4. Link Output: Connect two or Party Mix Pros together using an 1/8" (3.5 mm) stereo aux
cable from the Link Output of one Party Mix Pro to the Aux Input of the second Party Mix
Pro.
5. Headphone: Connect headphones to this 1/8" (3.5 mm) jack for monitoring the signal. The
headphone volume is controlled using the Cue Gain knob.
6. Mic Input: This mono input accepts a 1/4" (6.35 mm) input such as a microphone, guitar,
or other musical instrument.
7. USB: This USB connection sends and receives audio and control information from a
connected computer or mobile device.
4
3
6
7
1
5
2
7